Last week I shared my experience here about something that surprised me of prototype of my first product.
It looks great in quality but some details had been adjusted by supplier without any notification. The discussion and comments here gave me a lot of helpful and useful perspectives.
After thinking more about it, I realized a few points as a first-time founder for manufacturing products:
- A good prototype doesn't mean it is also good when scale.
- Specs and details need to be clearly confirmed early before mass production.
- Supplier should evaluate the product and point out the technical information or anything need to be adjusted for production feasibility.
- Changes should always be communicated and approved in advance.
- Process updates are critical.
The biggest lesson I have learned is that the issue is less about a single design/ detail change, it is more about the process control during manufacturing. It is a system.
For founders building physical products, what surprised you most when moving prototype to production? Or what you learned most?
My first prototype looks great, but it taught me an important lesson
byu/Unable_Fishing_1679 inEntrepreneur
Posted by Unable_Fishing_1679
2 Comments
One thing that surprised me the most is how small issues multiply at scale. A tiny design change or tolerance that looks fine in a prototype can become a big cost or quality problem when you’re producing hundreds or thousands of units. That’s when you realize manufacturing is less about the product and more about process control and clear documentation.
My biggest lesson: The factory will always choose the path of least resistance unless a spec is documented as “non-negotiable.” If it’s not in the signed off Golden Sample or the SOP, it’s up for interpretation. Process control isn’t just a system; it’s your only insurance policy.
Are you planning to do an onsite inspection or a pilot run before the full scale up?